Alienware M17x R4, Struggling to get 3D Working

[Durabat]

I have a R4 with the 120hz 3d screen, but the emitter isn't picking up or something. I'm sure I'm missing something, hopefully just software related but I've hit a wall and can't figure it out. I tested the screen on the R3 before moving it over to the R4, it worked fine. The screen itself is working fine, I have it set to PEG in the bios and it's running at 120hz currently. However, Stereoscopic settings are not showing up in the control panel and I even tried 3D Fix Manager but it shows emitter not detected and also says panel doesn't support 3D, when it just did fine prior to swapping it over. The R3 was on Windows 11 at the time, just like the R4 is. 

 

It shows up in device manager as Nvidia 3D Controller, I assume all is good there, and it shows working fine. I'm on the lastest driver that supported 3D vision, 425.31 or whatever it is. Still nothing. I don't have the integrated graphics driver installed so it only runs on the 680M. I've reseated everything multiple times, just to be sure but still... no 3D. 

 

I do have a 2nd 680m in another R4, I'll try swapping it in just to see what happens. I will say, for some reason I had to do modified drivers even on the 680m because the Nvidia installer said it couldn't find compatible hardware. Maybe something is wrong with this 680m, idk.

 

Any thoughts or ideas are much appreciated.

[Durabat]

I did just read in an old thread from Tech inferno that the R3 screen is not compatible with R4 for 3D. If that's true, that's unfortunate, but explains everything. 

[ssj92]

I don't remember if 3d was an issue, maybe @Maxware79 remembers if R3 3d panel works for r4 with 3d. I know the AW logo doesn't work