Ray Tracing on M18xR2 - RTX 3000 MXM Upgrade!

[janepa]

20 hours ago, ssj92 said:

We can try that one after. 

 

Once you test on your normal board, try doing the rebar enable through command prompt. 

 

Also, in the BIOS there's a setting called MAX TOLUD. I think default is 2.25GB or 2.5GB. 

 

After you have tried the command prompt enable (even if it works or not). Go to bios and change MAX TOLUD value to "Dynamic". Then see if it works. 

 

I don't think it's exactly the same as above 4g decode, but should help hopefully. 

 

 

Okay, I have new insights. After rebooting,  restarted ReBarState again and this is result .

 

 

Unfortunately after few seconds windows was freezing and after reboot again and in safemode too ,but i think rebar was created what i watch on sreenshot. I will try a new install of windows and see .

 

[ssj92]

11 hours ago, janepa said:

Okay, I have new insights. After rebooting,  restarted ReBarState again and this is result .

 

 

Unfortunately after few seconds windows was freezing and after reboot again and in safemode too ,but i think rebar was created what i watch on sreenshot. I will try a new install of windows and see .

 

Look for MAX TOLUD in BIOS. try changing to dynamic, if that doesn't work, then try 1GB, 1.25GB, 3GB, 3.25GB etc. Try the different values and see if it helps. 

 

According to you rebarstate, it is on, so it is working. You can try a higher value, instead of 8 you can try 16 etc.