-
Posts
212 -
Joined
-
Last visited
-
Days Won
5
Content Type
Profiles
Forums
Events
Everything posted by Meaker
-
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Clean connector is fine, they just needed to balance the wires like they did to start with the 3090 and with a warning if it got to unbalanced to plug the cable back in or replace it. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Oh no, it works with the reaper too, I don't need water cooling, I don't need water cooling 😄 -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
That was this FTC decision, all 3 are VERY conservative leaning judges. It's a 50/50 distribution of judges at the moment between republican and democrats nation wide in the courts. Also I meant to say court of appeals for the 8th circuit where the balance is this: Active Article III judges by appointing political party Below is a display of the number of active judges by the party of the appointing president. It does not reflect how a judge may rule on specific cases or their own political preferences. Democratic appointed: 1 Republican appointed: 10 Senior judges by appointing political party Below is a display of the number of senior judges by the party of the appointing president. It does not reflect how a judge may rule on specific cases or their own political preferences. Democratic appointed: 0 Republican appointed: 6 Blaming this FTC decision on woke liberal judges is a little far fetched. This was corperate protection over the interests of the American people. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Those judges were appointed by Bush and Trump and the republican members of the FTC voted against it. The 8th circuit is predominantly republican IIRC. The rulings of those judges have notably been anti LGBT, anti union and on the whole conservative leaning. So very strongly right leaning in this case. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Is it actually accelerated on the NPU yet? -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Does this version come with bonus rust though? -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Yeah but that's like saying I tuned my 5L V8 engine and got more than a whole 1.0L 3 cylinder eco boost out of it. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Normally with shunt modding my concern is the VRMs but in this case it's the connector 😄 -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
It's hard to really lay anything down on a fully sold out market. AMD ran through their stock as did Nvidia. I got mine at MSRP and have found the drivers much better for my use case. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
We will see, whatever your views the proof will be in the eating on that one. There is some execution detection going on and self limiting going on with certain instruction inputs. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Decent cooler/Voltage tweak/fan curve tweak gets them into safe levels. I run a slight undervolt and then a power reduction that keeps me around stock performance levels for a boat load less power which is nice at the moment. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
The rumour is this month and last month is a price lul with stock brought in before tariffs, then as that dries up as we go into back to school and christmas prices will rise again and could a fair amount. -
It's more there is not volume inside for air to flow around them so they go from being heatsinks to thermal mass that just traps the heat.
- 1 reply
-
- sodimm
- clevo x170km-g
-
(and 3 more)
Tagged with:
-
The mobile 3080ti core just can't scale either due to the reduced ROP count for it's size or memory bandwidth compared to the mobile 3080 core at the power levels of the 3080 mobile even shunt modded. A 3080 mobile with the 0.9v voltage limit raised in the 210W range IMO would still make more sense power/performance wise.
-
Picked up the NAS on the left for pretty cheap 2nd hand and repaired the one on the right from work. Left one will backup the right one, need to scrounge some disks for that, the primary will be the 3x12TB in raid 5 and a 500GB SSD for the OS.
-
I got my picture and name/details all updated on my passport ready for ours trip to Amsterdam 🙂
-
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
I have a work laptop (Lenovo T14 thinkpad) and my old GS30 that I use for things like dumping microSD footage or programming my car's ECU. But otherwise I just have my phone and tablet while on the go (S7+ tablet which I use for my choir sheet music mostly and flip 6 phone which fits really easily into a handbag or even evening little black bag). The Gen5 capable riser from my old case did not fit the new bracket on this case so I drilled a couple of extra holes in the PCB to make it work 🙂 -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
No, I think i'm sorted for now. I think I will wait CPU wise for the next AM5 gen. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
Decided to change out my case, also got a new card after a bearing issue with the fans. This one seems much happier. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
-
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
I just hope they hit that sweet spot and keep the drivers up, if they can get some volume and purchase in the market it will be a good thing. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
They focussed their driver and wafer capacity on a single die, we may see a 9070XTX with an even higher TDP, faster/denser ram. But that's it I think this gen. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware
The MEG display has been a trooper so far, seems even happier with the 9070xt than it did the 4070. -
*Official Benchmark Thread* - Post it here or it didn't happen :D
Meaker replied to Mr. Fox's topic in Desktop Hardware