clevo We did it. TM1 heatsink has been grafted to KM1

[zerokool]

On 7/20/2025 at 10:21 AM, Kalman said:

I have a DM2 and currently working on to fit the TM1 CPU cooler.

The frame must be cut to fit the extra radiator above the VRM.

And the hardest part is the mounting screws are 4mm lower on the TM1 than the Dm2 CPU cooler.

 

Ahh so how did you address the height difference ? 

[Kastner]

2 hours ago, zerokool said:

Ahh so how did you address the height difference ?

I have not yet. I thought about there are three solution. 

1. Cut off the bracket screw to the correct height and hope there is enough thread.

I do not want to do that.

2. Put something under the bracket to lower the screw height on the other side.

There is maybe not enough room beetwen the bracket and frame at the keyboard. Also you need longer bracket holder screws.

3. Make a new bracket holder out of isolation plate.

I will try this but still waiting for parts to arrive.

[zerokool]

1 hour ago, Kalman said:

I have not yet. I thought about there are three solution. 

1. Cut off the bracket screw to the correct height and hope there is enough thread.

I do not want to do that.

2. Put something under the bracket to lower the screw height on the other side.

There is maybe not enough room beetwen the bracket and frame at the keyboard. Also you need longer bracket holder screws.

3. Make a new bracket holder out of isolation plate.

I will try this but still waiting for parts to arrive.

Cool looking forward to your findings 🙂