MaxxD
-
Posts
344 -
Joined
-
Last visited
Content Type
Profiles
Forums
Events
Everything posted by MaxxD
-
It worked perfectly for me. In the case of a normal laptop, this option is not available because the cooler mount does not exert enough force and the Kryosheet does not fit snugly, thus there is no proper heat transfer. This is still good and available in the case of DTR Clevo.😋
-
I have been using TG Kryosheet chips for some time, both on CPU and GPU surfaces. It worked for me! In principle, this does not dry!☝️🤗🙃
-
Correctly: RTX 3080
-
RTX 3080 I bought it from here last year, I can only recommend it!☝️✌️😝
-
It must be dead...😌🙄
-
Paste again, that's the minimum. It is recommended to reapply once a year!☝️
-
Drivers, Bios, any any etc ... (XMG/Schenker) BIOS, EC (name/psw: repo / repo) Good luck! ✌️
-
The location of your cooling screw is also starting to wear, mine was worn by the spring screw and I replaced it with the manufacturer under warranty. I recommend using a special thermal plastic washer under the spring screw. I got a screw from the manufacturer. Complete screw set for the X170 model and separate CPU and GPU cooling spring screws. I think it's still available. Write to the manufacturer! The German Clevo XMG/Schenker was closer to me and I bought it from them. Good luck! Old: New: Screw sets:
-
I also bought a new KM-G board and will replace the SM-G board with it. I will be curious as to what kind of BIOS it will have and what problems will arise.🤔😄
-
I remember someone loaded it with a 4TB SSD and it was fine.🙄🤔
-
In principle, 4TB SSDs should be handled without any problems, or am I wrong?🤔
-
Did you succeed in replacing the page? Is everything ok? Write a few lines about it!✌️
-
New MB and CPU. At some point I will replace the SM-G board with this one.☝️✌️😉
-
That config needs to know a lot more.☺️
-
In principle, it has to be popped up from one side and then the other.
-
It hasn't arrived yet. USA comes to EU territory. It is expected to arrive before Christmas.
-
I also bought a new (Sager) KM-G motherboard and I don't know what BIOS version it will have. I hope it won't be a surprise! 🤔
-
I think "Set to Default BIOS" has been tried, if not then I recommend this. Or a full BIOS reset wouldn't hurt either. If this solves your problem, if not, it is recommended to take it to a service center for repair.
-
Link (Repo) Download Maybe this?😉 (user name / password: repo) ☝️
-
If it is not available on the official Clevo website, it is a pass.🙄 I haven't encountered such a problem so far.
-
XMG Download This is the official XMG download page - update the BIOS at your own risk!
-
I also used PK1 and PK3 paste. It fit perfectly! I am currently using Thermal Grizzly Kryosheets on both CPU and GPU.☺️
-
And it has to be good. Put an appropriate amount of dots in the center and fix the cooling correctly. That must be good!🤔
-
The first thing I notice is that there is not enough paste between the two surfaces. What exactly is the paste you use? I can recommend the Noctua NT-H2 paste! Try that.✌️
-
Hi, Check how well the paste spreads on the cooling surface. Cooler, have any changes been made? Are the screws correct? Share with us a picture of the paste surface after removing the cooler.
