Jump to content
NotebookTalk

Recommended Posts

Posted
14 minutes ago, GuitarG said:

With good programing skills and ai it may be possible to distill and extract exact reason why 8570w recognized eDP panel fully only with K1000m, as rtx quadro did not (worked but not recognized as internal panel, only as one of DP external monitors). I still think its vbios rom issue.

 

This can also be du to the EDID information on the LCD itself since the LCD communicates witht the GPU on the eDP AUX lanes.

 

For your custom cable, you used micro coaxial cables for the data lines ?

Precision M6700 : i7-3740QM | P3000 6gb engineering vbios | 20gb DDR3 1600Mhz | FHD ips dreamcolor | delta fans

Zbook 17 g3 : i7-6820HQ -75mv | M3000m 4gb | 16gb DDR4 2400Mhz | FHD ips 

Precision 7720 : i7-6820HQ -80mv & 102.7mhz BCLK| Zotac GTX1060 6gb, 100w OC vbios | 16gb DDR4 3011Mhz |  1440p165hz (upgrad)

Zbook 17 g5 : i7-8850H, -140mv | P5200 16gb | 32gb DDR4 2666Mhz | FHD IPS

 

Posted
32 minutes ago, GuitarG said:

Yes, DC set eats battery like kids eat candy. 

Red tint, sometimes high pitched noise (had both). Even if one can fight tint with colorimeter, its not worth IMO. 

 

My 40pin cable didnt worked only because my 40pin 4k screen was damaged. It tried to show image few times (text, no tv signal noise static, etc), then went totally blank. Later I tried that lcd on my zbook g9 and, suprise suprise, not working at all. 

 

Maybe one day I will find affordable 40pin screen so I can show you that would work same way as 30pin worked. Only difference is two additional lanes pairs.

 

With good programing skills and ai it may be possible to distill and extract exact reason why 8570w recognized eDP panel fully only with K1000m, as rtx quadro did not (worked but not recognized as internal panel, only as one of DP external monitors). I still think its vbios rom issue.

 

Dunno about red tint, my two DCs (8570w and Zbook 17 G1) don't have it. Maybe it can also be alleviated by applying a different profile on HP Mobile Display Assistant (rare to find on the web if I recall correctly, I have a copy of it attached)?

Coil whine / high pitched noise can be fought very effectively with common superglue.
Only the DC on ZBook had it, I generously doused/infiltrated all coils with superglue and the noise went from annoying to barely perceivable, and only when you hold your ear very close to the screen. Edit/addition: clear nail varnish is also an option.

HP Mobile Display Assistant.zip

Posted

Come to think of it, I still have a Quadro P3000 in storage with the 75W bios on it.
Could drop it into the 8570w with DC (maybe also using the 50W bios to keep temps down) instead of M1000M,
though I am very hesitant to brutalize the board by removing the SATA connector.
I still have this machine in very productive use for administrational purposes for my local football club, mainly used on dock with MST hub and triple monitors (all digital, no VGA). Maybe some time in the future, who knows 🙂 

Posted
On 11/16/2026 at 10:08 AM, Daedalus said:

@JadeRover The cables / board etc you show, those are G1 right? not 8570W? Is it only DC that unlocks the ability to go to P5200/RTX level? Could the "universal cable" give just as good an option? DC is great as its 10-bit screen, however if the MoBo isnt "detecting" the difference of screen installed, why the CardX wont work,but CardY will. So there must be a handshake that happens with DC that doesnt for LVDS that results in it displaying on internal.

 

Previously I showed zbook 17 g1 and g2 cables + interposer as well as the dell M6700 ones. I couldn't find pictures for 8570w nor 8770w.

 

I would assume that zbook, precision and elitebook all use a different DC setup with different pinouts and interposers.

 

As said before, what unlocks the P5200/RTX level upgrade is the eDP interface that is associated with DC screen OR with custom eDP cable to eDP display. The "universal cable" would be just as good for upgrade to a newer card yes.

 

I don't know about a motherboard handshake. Looking at the schematics of the M6700 and 8770w :

- M6700 has "RGB_PNL_DETECT" and "EDP_DETECT" pin on the lcd connector so the motherboard knows when a DC screen is connected

- 8770w has no such pins, only the eDP Hot Plug Detect (required signal)

 

However this makes sense since on the elitebooks only the dedicated GPU can drive the internal LCD, on the m6700 the iGPU can drive the LVDS display so the motherboard must signal to the CPU to enable it's integrated graphics or not, there is no need for this on the eliteboks hence no "handshake" pins.

 

Here is what happens on elitebooks with DC:

GPU powers up -> sees that eDP HPD signal is active meaning an eDP display is attached -> goes into eDP mode -> sends eDP i2c communication signals up the cable into the interposer -> interposer communicates with dGPU (resolution, refresh rate, pixel bit size, etc...) -> GPU sends the correct eDP DATA signals thanks to the info it received -> interposer converts them into High bandwidth LVDS -> LVDS goes to the DC display -> picture.

Precision M6700 : i7-3740QM | P3000 6gb engineering vbios | 20gb DDR3 1600Mhz | FHD ips dreamcolor | delta fans

Zbook 17 g3 : i7-6820HQ -75mv | M3000m 4gb | 16gb DDR4 2400Mhz | FHD ips 

Precision 7720 : i7-6820HQ -80mv & 102.7mhz BCLK| Zotac GTX1060 6gb, 100w OC vbios | 16gb DDR4 3011Mhz |  1440p165hz (upgrad)

Zbook 17 g5 : i7-8850H, -140mv | P5200 16gb | 32gb DDR4 2666Mhz | FHD IPS

 

Posted

I'm curious like is there really all that much of a reason to do all this for such an old laptop at this point? Ivy Bridge is pretty cool for doing cursed setups that Haswell+ cant, but like all these GPU upgrades put it firmly in the modern only category, but with old old CPU. I feel like my M4800 is a bit sluggish and idk if this really is the way to go.

 

If it's like the chassis and everything around it, why not take like an X210AI approach to it? These MXM cards are so rare and/or prohibitively expensive that if you got the money for that, you got the money to build a new board for the old case I'd think.

 

As someone poor, I've just been watching listings to try to get ZBook 17 G5 with P5200, as the price of a P5200 itself is the price of the entire laptop in previous sold listings, and I get the benefit of the best model of CPU and stuffs and it will like just work. Except both are slim pickings so I expect to be waiting a while.

Precision M4800 - i7 4810MQ, 32GB RAM, Nvidia Quadro M2200

Thinkpad T430 - i7 3630QM, 16GB RAM, Intel HD 4000, 1080p display mod

Main PC - AMD Ryzen 9 5950X, 64GB RAM, RTX 2080 Ti

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue. Terms of Use